Digimerge DND7220 Series Руководство по быстрой установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Камера безопасности Digimerge DND7220 Series. Digimerge DND7220 Series 20 страниц. High resolution dual-codec vandal resistant day/night dome network camera

Печатать страницу

Continued

Hardware Installation - Connecting the Cable

The Camera has a single cable, which splits into

several different connection ports:

1. Ethernet: Connect an Ethernet Cable to the

RJ-45 Ethernet port to connect the Camera to

the network.

• The Red PWR LED indicates the Power state

of the Camera (ON/OFF).

• The Green NET LED indicates the Network

state of the Camera. The LED will blink when

network communication occurs.

2. BNC: Connect a BNC Cable to view the Camera

on a CCTV Monitor or DVR with analog

(non-IP)Video inputs. This is an optional

connection.

3. Audio: Connect an RCA Cable to the audio

port on a CCTV Monitor or DVR (when using a

BNC Video Connection) to listen to Audio from

the camera. This is an optional connection.

4. Alarm Block: The Camera Alarm Block can be

used to send or receive a signal from a

compatible DVR or CCTV System. Please

consult the manual for the device you wish to

connect to the camera for details.

i. Use a small screwdriver to loosen the selected

screws.

ii. Insert the cables for the Alarm, NO, COM or

GND (as needed)

iii. Use the screwdriver to tighten the screws to

hold the cables in place.

5. Power Adaptor: Connect one end of the Power

Adaptor to the camera once all other

connections have been made. Connect the

other end to a compatible power source.

w w w

d i g i m e r g e

c o m

DND70 Series_Quick Installation Guide_En_R1

HARDWARE CONNECTIONS

Page

4ii