Cisco 2970 - Catalyst Switch Руководство - Страница 14
Просмотреть онлайн или скачать pdf Руководство для Переключатель Cisco 2970 - Catalyst Switch. Cisco 2970 - Catalyst Switch 19 страниц. Ios software release 12.1(14)ea1
Также для Cisco 2970 - Catalyst Switch: Бюллетень продукции (5 страниц), Бюллетень поддержки продуктов (6 страниц), Бюллетень поддержки продуктов (6 страниц)
Печатать страницу
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Use a null-modem cable to connect the switch to a remote DCE device, such as a modem or a Data
Service Unit (DSU). Use a straight-through cable to connect the switch to a data terminal equipment
(DTE) device, such as a terminal or a PC.
The console port of the Catalyst 4000 Supervisor Engine I uses a DB-25 connector and supports Data
Terminal Ready (DTR), Data Set Ready (DSR), Clear To Send (CTS), and Request To Send (RTS)
handshake signals.
Table G-1
Table G-1: Catalyst 4003 Console Port Pinouts
Pin
Signal
1
Ground
2
RxD
3
TxD
4
CTS
5
RTS
7
Ground
8
DTR
20
DSR
Connecting a Terminal to the Catalyst 4000/4500
Supervisor Engine II/II+/III/IV, 2948G, 2980G, and
4912G
You may configure the Catalyst 4000/4500 series switches from a direct console connection to the
console port.
Use the RJ-45-to-RJ-45 rollover cable and RJ-45-to-DB-9 female data terminal equipment (DTE)
adapter (labeled "Terminal") to connect the console port to a PC running terminal emulation
software. If you are using a direct console connection, configure your terminal emulation program
for 9600 baud, 8 data bits, no parity, and 1 stop bit.
Table H-1
lists the switch console port pinouts. Use a straight-through cable to connect the switch to a
DTE device, such as a terminal or a PC.
Table H-1: Catalyst 4000/4500 Supervisor II and higher, 2948G, 2980G, and 4912G Console Port
http://www.cisco.com/warp/public/473/9.html (14 of 19) [9/4/2003 12:36:03 PM]
lists the Catalyst 4000 Supervisor Engine I console port pinouts.
Direction
Input
Receive Data
Output
Transmit Data
Input
Clear To Send
Output
Request To Send
Output
Data Terminal
Input
Data Set Ready
Description