Cisco 3020 - Cisco Catalyst Blade Switch Руководство по началу работы - Страница 24

Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 31 страница. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Также для Cisco 3020 - Cisco Catalyst Blade Switch: Руководство по началу работы (37 страниц), Quickspecs (12 страниц), Примечание к выпуску (41 страниц), Примечание к выпуску (27 страниц), Примечание к выпуску (23 страниц), Примечание к выпуску (21 страниц), Руководство по установке (21 страниц)

CAB-STK-E-0.5M= (0.5-meter cable)

–

CAB-STK-E-1M= (1-meter cable)

–

CAB-STK-E-3M= (3-meter cable)

–

For switch module dimensions and additional stacking guidelines, see the switch module hardware

installation guide. For concepts and procedures to manage switch stacks, see the switch module

software configuration guide and the stack compatibility guide.

To create a switch stack:

Step 1

Install the member switch modules if you have not already done so.

Connect the StackWise Plus cables as described in the "Planning and Creating a Switch Stack

Step 2

(Only the Cisco Catalyst Blade Switch 3120 for HP)" section on page 23.

Step 3

Configure the member switch modules through the master switch by using the CLI.

Stack Cabling Configurations

This example shows a single chassis with two switches that create one stack. The stack uses the 1-meter

StackWise Plus cable to make redundant connections between two 3120 switches. Other types of

configurations are possible provided that you stack no more than nine switches. For more stacking

configuration examples, see the hardware installation guide.

Follow these steps:

Remove the dust covers from the StackWise Plus cables and store them for future use.

Step 1

Step 2

Verify that cables are aligned as shown in Figure 11.