FIBARO FGBHCD-001 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары FIBARO FGBHCD-001. FIBARO FGBHCD-001 12 страниц.
Печатать страницу
#5: Operating the device
Menu allows to perform different actions. In order to use the menu:
1. Press and hold the button for 3 seconds.
2. You should hear a short signal while the LED diode blinks white.
3. Release the button.
4. wait for the device to indicate desired menu position with a colour:
•
White - confirm the start of the firmware update process
•
Green - send the current state of CO Alarm
•
Magenta - reset the CO peak value
•
Yellow - the device reset
5. Press the button to confirm selection.
Resetting the accessory to factory defaults:
Reset procedure allows to restore the accessory back to its factory
settings including HomeKit pairing. Stored carbon monoxide and
temperature measurement are not deleted.
1. Press and hold the button.
2. Release the button when LED indicator glows white and short
beep sounds.
3. Click the button when LED indicator glows yellow.
4. After few seconds the device will be reset (confirmed by red LED
indicator and long beep).
Self-test allows to check operation of the accessory.
To start the self-test:
1. Press and hold the button.
2. The LED indicator will glow white and you will hear a short beep.
3. Release the button when you hear the first alarm sequence.
4. Move away from the accessory to protect your hearing.
If the self-test procedure does not result in emitting sound
!
and red light signal, replace the accessory.
Button
i
NOTE
CO Sensor must be de-
tached from the wall
and battery level must
be greater than 30%
of its full capacity to
perform the firmware
update process.
!
CAUTION
The alarm is very loud!
Only the first alarm se-
quence is quieter.
OPERATING THE DEVICE
7