FIBARO FGBHCD-001 운영 매뉴얼 - 페이지 7

{카테고리_이름} FIBARO FGBHCD-001에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FIBARO FGBHCD-001 12 페이지.

페이지 인쇄

#5: Operating the device

Menu allows to perform different actions. In order to use the menu:

1. Press and hold the button for 3 seconds.

2. You should hear a short signal while the LED diode blinks white.

3. Release the button.

4. wait for the device to indicate desired menu position with a colour:

•

White - confirm the start of the firmware update process

•

Green - send the current state of CO Alarm

•

Magenta - reset the CO peak value

•

Yellow - the device reset

5. Press the button to confirm selection.

Resetting the accessory to factory defaults:

Reset procedure allows to restore the accessory back to its factory

settings including HomeKit pairing. Stored carbon monoxide and

temperature measurement are not deleted.

1. Press and hold the button.

2. Release the button when LED indicator glows white and short

beep sounds.

3. Click the button when LED indicator glows yellow.

4. After few seconds the device will be reset (confirmed by red LED

indicator and long beep).

Self-test allows to check operation of the accessory.

To start the self-test:

1. Press and hold the button.

2. The LED indicator will glow white and you will hear a short beep.

3. Release the button when you hear the first alarm sequence.

4. Move away from the accessory to protect your hearing.

If the self-test procedure does not result in emitting sound

and red light signal, replace the accessory.

Button

NOTE

CO Sensor must be de-

tached from the wall

and battery level must

be greater than 30%

of its full capacity to

perform the firmware

update process.

CAUTION

The alarm is very loud!

Only the first alarm se-

quence is quieter.

OPERATING THE DEVICE