Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector Руководство по эксплуатации - Страница 38

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Проектор Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector. Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector 49 страниц. Colour inkjet printer
Также для Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector: Руководство по эксплуатации (49 страниц), Основная информация и препараты (10 страниц), Руководство по эксплуатации (47 страниц)

When the STATUS Indicator Illuminates or Flashes

Status Light Messages

Condition

OFF

On Continually

Flashing Very Rapidly (On and

off in a cycle of 1 sec.)

Flashing Rapidly

(On and off in a cycle of 4 sec.)

Flashing Slowly (On and off in a

cycle of 8 sec.)

Flashing Very Slowly (On and off

in a cycle of 12 sec.)

STATUS indicator

POWER

STATUS

ON/OFF

INPUT SELECT AUTO SYNC

Status

Normal

The lamp usage has exceeded 1000 hours of operation and should be

replaced.

• The lamp cover is not correctly attached. Replace it correctly.

• The temperature protector has been triggered. If the room temperature is

high, move the unit to a cool location. If the temperature within the unit is

high, check the cooling fan (exhaust vent) and the cooling fan (exhaust

vent) on the bottom of the unit. If any of the slots are blocked, remove

whatever is blocking them.

• The temperature protector has been triggered. If you try to turn on the

unit immediately after turning off, sometimes the power does not come

on. If this happens, wait at least one minute, then turn on the unit again.

• The lamp lighting voltage error detection protector has been triggered.

Wait at least one minute before turning on the unit again. If this does not

solve the problem, please contact your dealer.

The cooling fan has stopped. Contact your Sharp Authorized LCD Projector

Dealer or Service Center.

The lamp is not turned on.

• The unit was turned on immediately after being turned off. Turn off the

unit, wait at least one minute, then turn on the unit again.

• The lamp is dead. Replace the lamp cage. (See page 37.)