Digital Data Communications Level One GTL-2091 Руководство - Страница 7
Просмотреть онлайн или скачать pdf Руководство для Переключатель Digital Data Communications Level One GTL-2091. Digital Data Communications Level One GTL-2091 14 страниц. Stp optional characteristic configuration commands
Также для Digital Data Communications Level One GTL-2091: Руководство (6 страниц), Руководство (5 страниц), Руководство (18 страниц), Руководство (9 страниц)
Печатать страницуEnabling remote OAM loopback
l
l
Configuring OAM link monitoring
l
Configuring the trouble notification from remote OAM entity
Displaying the information about OAM protocol
l
1.3 OAM Configuration Tasks
1.3.1 Enabling OAM on an Interface
Run the following command to enable OAM:
Proced
ure
Step1
config
Step2
interface intf-type intf-id
Step3
ethernet oam
Step4
ethernet oam [max-rate oampdus |
min-rate seconds | mode {active |
passive} | timeout seconds]
You can run no Ethernet oam to shut down the OAM function.
The remote OAM loopback cannot be enabled on the physical interface that
belongs to the aggregation interface.
1.3.2 Enabling Remote OAM Loopback
The procedure to enable remote loopback on an interface is shown in the
following table:
Proced
http://www.level1.com
Command
Command
Purpose
Enters the global configuration mode.
Enters the interface configuration mode.
Enables Ethernet OAM on an interface.
Configures optional OAM parameters:
l
The max-rate parameter is used to configure
the
maximum
number
transmitted per second. It ranges between 1
and 10 and its default value is 10.
l
The min-rate parameter is used to configure
the minimum transmission rate of OAMPDU.
Its unit is second. It ranges between 1 and 10
and its default value is 1.
l
The mode {active | passive} parameter is
used to set the mode of OAM. The OAM
connection can be established between two
interfaces only when at least one interface is
in active mode.
l
The timeout parameter is used to set the
timeout time of the OAM connection. It ranges
between 1 and 30 seconds and its default
value is 1 second.
Purpose
OAM Configuration
of
OAMPDUs
- 5 -