Digital Everywhere FloppyDTV Руководство по сборке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по сборке для Приемник Digital Everywhere FloppyDTV. Digital Everywhere FloppyDTV 4 страницы.

4. Hard Drive or Floppy Drive bay assembly instructions

The FloppyDTV can be mounted on any 3,5" bay in the computer using a special 3,5" adapter.

The 3,5" Adapter is not included in all the available versions of the FloppyDTV. Contact your

dealer if your versions doesn't include the 3,5" Adapter.

To mount a FloppyDTV into the 3,5" Floppy Drive bay of your computer follow the instructions below.

•

Remove both the PCI and PCI-e flaps by bending them firmly

•

Remove the two screws holding the PCI Bracket

•

If you want to use a FireWire connector on your

motherboard, prepare the FireWire cable of the FloppyDTV

as described in the section 1.3.

•

Assembly the 3,5" adapter using the screws included in the

package

•

Connect the included RF-cable to your FloppyDTV receiver as

shown in the picture.

•

Locate an empty 3.5" Floppy Drive bay and remove the panel cover.

Slide the FloppyDTV receiver into the drive bay.

•

Connect the power cable of the FloppyDTV receiver with the power

supply cable of the computer.

•

Connect the FireWire cable as described in section 1.

5. General assembly notes

•

Avoid any sharp bend or crushing of the FireWire or antenna cable

•

Avoid contact of the FloppyDTV component to any metal or electronic part of the computer.

Special care has to be taken to avoid contact to Heat Sinks or Fans in the computer

•

Avoid any kind of modification of FloppyDTV not mentioned in this guide

070928-v2.1

FloppyDTV - Assembly guide

Page 4

Tighten the screws