Ricoh SR770 Руководство по установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке для Принтер "все в одном Ricoh SR770. Ricoh SR770 4 страницы. Punch kit type for machine code: g060; g080; g082; g106

Печатать страницу

Connect the cable of the 2 tray finisher to the lower

connector on the back of the printer.

Place the two 2 tray finisher trays in the 2 tray finisher.

Note

❒ The two finisher trays are identical.

³ Adjust the notch on the left side of the 2 tray finisher

tray to the cable coming out from the 2 tray finisher.

This step is unnecessary if you are using the lower area.

· With the 2 tray finisher tray laid horizontally, slide it in

at a slant until it stops.

» Fasten the finisher tray using a short screw and the

provided screwdriver.

¿ Use the same steps (· and ») to install the other 2

tray finisher trays.

Be sure to return the provided screwdriver to its original

position on the inside of the front cover.

Put the finisher tray installed on the duplex unit back in

place.

³ Lift the top.

· Lower slowly.

Note

❒ After finishing the installation, you can check the finisher is

installed properly: Print the configuration page from the "List/

Test Print" menu. If it is installed properly, you will see "2 Tray

Finisher" appear in the "Options" list. (G060, G080, G106)

❒ After finishing the installation, you can check the finisher is

installed properly: Print the configuration page from the "Print

Menu" menu. If it is installed properly, you will see "Finisher:

Installed" appear in the "Installed Options" list. (G082)

❒ If the finisher is not installed properly, repeat the procedure

from step

. If you cannot install it properly even after

reinstallation, contact your sales or service representative.

Printed in Japan

ZHXH360J

ZHXH370J

G565-8600C