G G G G
Press { { { { U U U U } } } } or { { { { T T T T } } } } to select the
transmission mode.
Note
❒ The factory default is "802.11
Ad hoc".
❒ To use an IEEE 802.11b card for
w h i c h t h e S S I D ( N e t w o r k
Name) setting is not necessary,
select "Ad hoc".
H H H H
Press { { { { Enter #} } } } .
The display returns to the previous
menu in a few seconds.
I I I I
If "802.11 Ad hoc" or "Ad hoc" is
selected for "Comm. Mode", set
the channel to use for transmis-
sion.
Note
❒ Confirm the network adminis-
trator for the channel to use.
A Press { { { { U U U U } } } } or { { { { T T T T } } } } to display
"Channel".
IEEE 802.11b:
Channel
B Press { { { { Enter #} } } } .
The channel currently used ap-
pears on the panel display.
Channel:
(1-11)
C Press { { { { U U U U } } } } or { { { { T T T T } } } } to enter the
channel.
D Press { { { { Enter #} } } } .
J J J J
K K K K
11
802.11b Interface Unit Type A
Set "Trans. Speed" in the same
way.
Note
❒ The factory default is "Auto". If
you need to change the trans-
mitting speed depending on en-
vironment you are using, select
the appropriate transmitting
speed.
Press the { { { { U U U U } } } } or { { { { T T T T } } } } key to dis-
play "SSID", and then press the
{ { { { Enter #} } } } key.
IEEE 802.11b:
SSID
The following message appears on
the panel display.
SSID:
Enter ID
Note
❒ The factory default is "ASSID".
❒ If an SSID has been set, you can
check the set SSID. Press the
{ { { { U U U U } } } } or { { { { T T T T } } } } key to display
"View", and then press the { { { { En-
ter #} } } } key.
A Press the { { { { Enter #} } } } key.
The following message appears
on the panel display.
SSID:
k
Note
❒ The value in brackets at the
upper right is the number of
characters entered.
1
[ 0]
29
Печатать страницу