Cisco 1600 series Краткое руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевой маршрутизатор Cisco 1600 series. Cisco 1600 series 8 страниц. Rdiag router analog ipsec
Также для Cisco 1600 series: Краткое руководство по эксплуатации (12 страниц), Установка или замена руководства (10 страниц), Руководство по установке оборудования (14 страниц)

Install the Router (continued).

B. Install the WAN interface card.

Look for a WAN interface card in the slot on the right-rear of the router, just above the slot labeled FLASH PC

CARD. (There is no WAN interface card installed if there is a metal plate over the slot.) If the card is already

installed, connect it to your WAN line according to the instructions that came with the card. To install a card,

follow the instructions below.

Note: You must provide a Phillips

screwdriver for this step.

Step 1

Conﬁrm that the power is OFF.

Step 2

Remove the thumbscrews that hold

the slot cover in place, and then remove the

slot cover.

Step 3

Hold the card by the edges and line it

up with the guide on the card slot.

Step 4

Insert the card into the slot and push

in until it is ﬁrmly seated in the connector and

the front panel is ﬂush with the router rear

panel.

Step 5

Tighten the screws that are in the

card.

Connect the card port to the WAN line

according to the instructions that came with

the card.