Cisco 1600 series Manual de início rápido - Página 5

Procurar online ou descarregar pdf Manual de início rápido para Router de rede Cisco 1600 series. Cisco 1600 series 8 páginas. Rdiag router analog ipsec
Também para Cisco 1600 series: Manual de início rápido (12 páginas), Instalação ou substituição do manual (10 páginas), Manual de instalação do hardware (14 páginas)

Install the Router (continued).

B. Install the WAN interface card.

Look for a WAN interface card in the slot on the right-rear of the router, just above the slot labeled FLASH PC

CARD. (There is no WAN interface card installed if there is a metal plate over the slot.) If the card is already

installed, connect it to your WAN line according to the instructions that came with the card. To install a card,

follow the instructions below.

Note: You must provide a Phillips

screwdriver for this step.

Step 1

Conﬁrm that the power is OFF.

Step 2

Remove the thumbscrews that hold

the slot cover in place, and then remove the

slot cover.

Step 3

Hold the card by the edges and line it

up with the guide on the card slot.

Step 4

Insert the card into the slot and push

in until it is ﬁrmly seated in the connector and

the front panel is ﬂush with the router rear

panel.

Step 5

Tighten the screws that are in the

card.

Connect the card port to the WAN line

according to the instructions that came with

the card.