Cisco NCS 4200 Series Руководства по конфигурации - Страница 4

Просмотреть онлайн или скачать pdf Руководства по конфигурации для Сетевой маршрутизатор Cisco NCS 4200 Series. Cisco NCS 4200 Series 30 страниц. 1 port oc-48/ 4 port oc-12/oc-3 + 12 port t1/e1 + 4 port t3/e3 cem interface module configuration guide, cisco ios xe fuji 16.7.x (cisco ncs 4200 series)
Также для Cisco NCS 4200 Series: Руководство по конфигурации (36 страниц)

Печатать страницу

Cisco NCS 4200 Series Руководства по конфигурации

Note

Recommended interfacing connector for the T3 VCoP SFP is Compel 1.0/2.3 Coaxial

connector P/N 350.064.621.

Restrictions

• The payload size is fixed to STS1 and is 783 bytes.

• VCoP smart SFP does not support Stateful Switchover (SSO).

• For QoS, VCoP smart SFP supports only the default MPLS experimental marking.

• At a time, OC-3/OC-12 supports BERT at any one path. T3 supports BERT only at one port.

• VCoP smart SFP does not support E3 mode.

• The chassis supports up to 12 VCoP smart SFPs.

• The T3 mode supports 1 CEP circuit and can sustain the traffic up to 45mbps.

• The Cisco NCS 4201 supports a maximum of 12 VCoP smart SFPs and only on GE ports of the top row.

• The Cisco NCS 4202 supports a maximum of eight VCoP smart SFPs and on all GE and 10GE ports.

• BERT on OCn VCoP is supported only at STS-1 path level. VCoP hardware does not support BERT at concatenated paths.

Alarms on VCoP Smart SFP

VCoP smart SFP supports the following alarms on OC-3 or OC-12 mode:

• Loss of Signal (LOS)

• Loss of Frame (LOF)

• Alarm Indication Signal (MS-AIS, AU-AIS)

• Remote Defect Indication Line (RDI-L)

• Loss of Pointer (AU-LOP)

• Path Unequipped Indication Signal (PUNEQ)

VCoP smart SFP supports the following alarms on T3 mode:

• Loss of Signal (LOS)

• Loss of Frame (LOF)

• Alarm Indication Signal (MS-AIS, AU-AIS)

• Remote Alarm Indication (RAI)