Cisco NCS 4200 Series Руководства по конфигурации - Страница 5
Просмотреть онлайн или скачать pdf Руководства по конфигурации для Сетевой маршрутизатор Cisco NCS 4200 Series. Cisco NCS 4200 Series 30 страниц. 1 port oc-48/ 4 port oc-12/oc-3 + 12 port t1/e1 + 4 port t3/e3 cem interface module configuration guide, cisco ios xe fuji 16.7.x (cisco ncs 4200 series)
Также для Cisco NCS 4200 Series: Руководство по конфигурации (36 страниц)
Печатать страницу
Configuring VCoP Smart SFP
Before You Begin
Ensure MPLS and IGP are active between the PE nodes.
VCoP smart SFP supports the following valid CEP Pseudo Wire (PW) configurations:
Note
Mode
OC-3
OC-12
T3
You can configure VCoP smart SFP on OC-3 or OC-12 mode.
1 Enable VCoP smart SFP using the platform command.
2 Configure controller for CEM circuits.
3 Configure xConnect for CEM circuit.
You can configure VCoP smart SFP on T3 mode.
1 Enable VCoP smart SFP using the platform command.
2 Configure controller for CEM circuits.
3 Configure cablelength.
4 Configure xConnect for CEM circuit.
Configuring VCoP Smart SFP on OC-3
Enabling VCoP Smart SFP on OC-3
You can enable VCoP smart SFP for STS1 and STS-3c channels on OC-3.
enable
configure terminal
platform smart-sfp interface GigabitEthernet 0/0/8 type OC-3
exit
Configuring Framing for CEM Circuits for STS-1 on OC-3
enable
configure terminal
controller SONET 0/0/8
framing sonet
sts-1 1
CEP PWs
3* STS-1 or 1* STS-3c
Valid mix of STS-1, STS-3c or STS-12c
1*STS-1
5