Cisco WAP121 Краткое руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Беспроводная точка доступа Cisco WAP121. Cisco WAP121 13 страниц. Reboot and reset to factory default settings
Также для Cisco WAP121: Обзор (6 страниц), Информационный лист (7 страниц), Брошюра и технические характеристики (4 страниц), Краткое руководство по эксплуатации (13 страниц), Руководство (4 страниц), Руководство (4 страниц)

To mount the WAP device to a wall or ceiling:

Determine where you want to mount the device. Verify that the

TEP

surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface 1.85 inches (47 mm) apart for

TEP

the Cisco WAP121. For the WAP321, drill the holes 2.75 inches

(70 mm) apart.

Insert a screw into each hole, leaving a gap between the surface

TEP

and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the

TEP

screws accordingly, and slide the bracket down until the screws fit

snugly into the slots.

Using the bracket as a template, drill two more holes for the lower

TEP

screws.

Insert a screw into each lower hole.

TEP

Slide the WAP device into the bracket, placing the cables or cords

TEP

through the break-out tab found in the back of the bracket.

Connecting the Cisco WAP121 and

WAP321 Wireless-N Access Points

To connect the device to the network:

Connect the Ethernet cable to the Ethernet port of a switch or a

TEP

router.

Connect the other end of the network Ethernet cable to the

TEP

Ethernet port of the wireless access point.

If PoE is not provided, for the Cisco WAP121 plug in the power

TEP

adaptor to provide power to the device. For the Cisco WAP321, the

power adaptor is sold separately.

After installation, all lights should be active. Refer to

Hardware Installation, page 6

switch.

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE

for details about the different lights on each

Verifying the