Cisco WAP121 Hızlı Başlangıç Kılavuzu - Sayfa 5

Kablosuz Erişim Noktası Cisco WAP121 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP121 13 sayfaları. Reboot and reset to factory default settings
Ayrıca Cisco WAP121 için: İnceleme (6 sayfalar), Veri Sayfası (7 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Hızlı Başlangıç Kılavuzu (13 sayfalar), Manuel (4 sayfalar), Manuel (4 sayfalar)

Sayfayı Yazdır

To mount the WAP device to a wall or ceiling:

Determine where you want to mount the device. Verify that the

TEP

surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface 1.85 inches (47 mm) apart for

TEP

the Cisco WAP121. For the WAP321, drill the holes 2.75 inches

(70 mm) apart.

Insert a screw into each hole, leaving a gap between the surface

TEP

and the base of the screw head.

Place the upper slots of the bracket over the screws, adjust the

TEP

screws accordingly, and slide the bracket down until the screws fit

snugly into the slots.

Using the bracket as a template, drill two more holes for the lower

TEP

screws.

Insert a screw into each lower hole.

TEP

Slide the WAP device into the bracket, placing the cables or cords

TEP

through the break-out tab found in the back of the bracket.

Connecting the Cisco WAP121 and

WAP321 Wireless-N Access Points

To connect the device to the network:

Connect the Ethernet cable to the Ethernet port of a switch or a

TEP

router.

Connect the other end of the network Ethernet cable to the

TEP

Ethernet port of the wireless access point.

If PoE is not provided, for the Cisco WAP121 plug in the power

TEP

adaptor to provide power to the device. For the Cisco WAP321, the

power adaptor is sold separately.

After installation, all lights should be active. Refer to

Hardware Installation, page 6

switch.

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE

for details about the different lights on each

Verifying the