Cisco Quick Set C20 Руководство по началу работы - Страница 26

Cisco TelePresence Systems

GettinG started Guide

Table of contents

Introduction

Web interface

Using the web interface for system configuration

You have to use the Touch controller or remote control for

the configurations until you know your system's IP address.

Finding the IP address

Tap

More > Settings > System Information

controller; or navigate to

Home > Settings > System

information

if you use the remote control and on‑screen

menu.

In both cases you will find the IPv4 Address and/or IPv6

Address of the system in the NETWORK section on this

System Information page.

Signing in to the web interface

1. Open a web browser and enter the system's IP address

in the address bar.

2. Enter your user name and password and click

The default user name is

admin

with no password set.

If you are not able to connect to the system:

• Make sure the system and computer are connected to

the same network.

• Make sure the system is switched on.

If the system has just been switched on, wait a few minutes

to allow the system to start up.

User interfaces

on a Touch

Sign

In.

Configuration

Appendices

The web interface