Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Примечание по установке - Страница 3

Просмотреть онлайн или скачать pdf Примечание по установке для Сетевое оборудование Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 страниц. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Также для Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Примечание по установке (14 страниц), Руководство по решению (17 страниц), Примечание по установке (46 страниц), Белая книга (19 страниц), Описание (1 страниц), Бюллетень продукции (6 страниц), Уведомление (4 страниц), Информационный лист (9 страниц), Информационный лист (18 страниц), Белая книга (18 страниц), Руководство по конфигурации (8 страниц), Примечание по установке (28 страниц), Руководство по устранению неполадок (11 страниц), Руководство пользователя (17 страниц), Примечание по установке (24 страниц), Руководство (19 страниц), Примечание по установке (36 страниц)

Печатать страницу
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Примечание по установке
Table 1
Catalyst Software
Release
7.x
8.x
The supervisor engine is a required system component. If only one supervisor engine is present,
Caution
removing it while the system is operating causes the system to halt.

Safety Overview

Safety warnings appear throughout this publication in procedures that may harm you if performed
incorrectly. A warning symbol precedes each warning statement.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this
device. Statement 1071
SAVE THESE INSTRUCTIONS
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
Warning
when servicing. Statement 1034
78-14357-02
Memory Recommendations and Requirements (continued)
Memory
Recommendation/
With software releases 7.5(1) and later, 64-MB DRAM may not provide
adequate free memory for all configurations. With large, existing configurations
using many features, or when enabling new features available in release 7.5 and
later, 64-MB DRAM might not be enough memory. We recommend upgrading to
128-MB DRAM to ensure that adequate free memory is available to the system at
all times.
Software release 7.6(4) and later 7.6(x) releases are too large to fit in the 64-MB
DRAM that originally shipped on some Supervisor Engine 1A modules. You
must upgrade to 128-MB DRAM.
With Catalyst software releases 8.1(1) and later, your Supervisor Engine 1A
configuration requires 128-MB DRAM.
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
Requirement
Safety Overview
3