Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalación - Página 3

Navegue en línea o descargue pdf Nota de instalación para Hardware de red Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 páginas. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
También para Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota de instalación (14 páginas), Manual de soluciones (17 páginas), Nota de instalación (46 páginas), Libro Blanco (19 páginas), Descripción (1 páginas), Boletín de productos (6 páginas), Aviso (4 páginas), Ficha de datos (9 páginas), Ficha de datos (18 páginas), Libro Blanco (18 páginas), Manual de configuración (8 páginas), Nota de instalación (28 páginas), Manual de solución de problemas (11 páginas), Manual del usuario (17 páginas), Nota de instalación (24 páginas), Manual (19 páginas), Nota de instalación (36 páginas)

Table 1

Catalyst Software

Release

7.x

8.x

The supervisor engine is a required system component. If only one supervisor engine is present,

Caution

removing it while the system is operating causes the system to halt.

Safety Overview

Safety warnings appear throughout this publication in procedures that may harm you if performed

incorrectly. A warning symbol precedes each warning statement.

Warning

IMPORTANT SAFETY INSTRUCTIONS

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you

work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar

with standard practices for preventing accidents. Use the statement number provided at the end of

each warning to locate its translation in the translated safety warnings that accompanied this

device. Statement 1071

SAVE THESE INSTRUCTIONS

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Warning

Statement 1030

Hazardous voltage or energy is present on the backplane when the system is operating. Use caution

Warning

when servicing. Statement 1034

78-14357-02

Memory Recommendations and Requirements (continued)

Memory

Recommendation/

With software releases 7.5(1) and later, 64-MB DRAM may not provide

adequate free memory for all configurations. With large, existing configurations

using many features, or when enabling new features available in release 7.5 and

later, 64-MB DRAM might not be enough memory. We recommend upgrading to

128-MB DRAM to ensure that adequate free memory is available to the system at

all times.

Software release 7.6(4) and later 7.6(x) releases are too large to fit in the 64-MB

DRAM that originally shipped on some Supervisor Engine 1A modules. You

must upgrade to 128-MB DRAM.

With Catalyst software releases 8.1(1) and later, your Supervisor Engine 1A

configuration requires 128-MB DRAM.

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

Requirement

Safety Overview