ACU-RITE 1113777-NN Обновление программного обеспечения

NOTE: HEIDENHAIN Corporation recommends making a backup of the control with the USB

Recovery Drive before updating the control software. Please refer to the manual included with

the drive for the backup procedure. Reference compatibility chart below.



R4SP5 cannot be installed unless you have R4SP4 installed first. If you have previous

version of software such as R1, R2, or R3 SPx (release 1, release 2, or release 3 with

any service pack) download and install R4 SP4 prior to updating to R4SP5.



Consoles with ID# 745604-NN cannot be upgraded to R5 and will continue to receive

service packs under the R4 release. Please do not attempt to install release 5 (R5) onto

these consoles.

If required contact your authorized ACU-RITE dealer to purchase the USB recovery drive

1201909-01 includes a compatible USB Recovery Drive ID# 680480-03 for original G2 consoles

(ID#745604-NN).

If a special PLC for AMI functions was created for your MILLPWR system. The PLC for R5SP1

may need to be modified in the same manner. Any OEM/User customizations to the PLC will

need to be reintegrated into the new PLC project.

All users can verify your software version from the DRO screen by pressing SETUP. If one of

your soft keys is labeled More Commands, you have release 1 (R1) software. If one of your soft

keys is labeled Install Setup, press this key. Enter the password 8891 and press Enter. The

installed software version will be displayed at the bottom left of your screen.

If any issues are encountered, please contact your service representative for assistance.

You can download the software release update free of charge from our web site at

rite.com. If you wish to purchase the software and operation manual from ACU-RITE, contact

your authorized dealer to place an order.

Installing the software onto your MILLPWR

Use a blank USB memory stick (1 GB or larger) to update the software. Do not use any memory

stick with a smaller storage capacity. The software installation files are required for updating the

software. When a USB memory device in placed in a USB port prior to boot up with the update

files setup.zip, and setup.ini located within a folder named "install", at boot up your G2 control

will detect the upgrade software files and proceed to install.

Procedure for downloading the update files and placing them on a USB drive.

Download the update from

Controls Tab.

For Use with Consoles (ID# 745604-NN) ONLY

system:

http://www.acu-rite.com/software-updates.html

February 3, 2017

MILLPWR

2 & 3 Axis

Release of Version R4SP5

www.acu-

found under the