ACU-RITE 1113777-NN Обновление программного обеспечения

These release notes include enhancements/changes for both R6SP4 and R7.

Please read below for the list of enhancements.

NOTE: HEIDENHAIN Corporation recommends making a backup image of the control with the

USB Recovery Drive before updating the control software. Please refer to the manual included

with the USB drive for the backup procedure. Reference compatibility chart below.



Prior to updating to R7 you must have R6 loaded, if you have a previous version of

software, confirm that R5 SP1 is installed and that you have resized the hard drive

partitions. Due to the enhanced features since release 5, repartitioning the console's

hard drive is required. USB Recovery Drive ID# 680480-04 includes an option for

resizing the control's hard drive partitions. This can only be performed on consoles

ID#1113777-NN that are running software release 4 service pack 4 (R4 SP4) or R5.

Please insure the console is updated to one of these releases prior to restructuring the

drive and installing release 7 (R7).



R5 cannot be installed unless you have R4SP4 installed first. If you have previous

version of software such as R1, R2, or R3 SPx (release 1, release 2, or release 3 with

any service pack) download and install R4 SP4 then proceed to update to R5.



Recovery Drive Kit ID# 1127022-01 can be purchased from your local ACU-RITE

distributor.

If a special PLC for AMI functions was created for your MILLPWR system. The PLC for R7 may

need to be modified in the same manner. Any OEM/User customizations to the PLC will need to

be reintegrated into the new PLC project.

All users can verify your software version from the DRO screen by pressing SETUP. If one of

your soft keys is labeled More Commands, you have release 1 (R1) software. If one of your soft

keys is labeled Install Setup, press this key. Enter the password 8891 and press Enter. The

installed software version will be displayed at the bottom left of your screen.

If any issues are encountered, please contact your service representative for assistance.

You can download the software release update free of charge from our web site at

rite.com. If you wish to purchase the software and operation manual from ACU-RITE, contact

your authorized dealer to place an order.

Installing the software onto your MILLPWR

Use a blank USB memory stick (1 GB or larger) to update the software. Do not use any memory

stick with a smaller storage capacity. The software installation files are required for updating the

software. When a USB memory device in placed in a USB port prior to boot up with the update

For Use with Consoles (ID#1113777-NN) ONLY

system:

July 9, 2018

MILLPWR

2 & 3 Axis

Release of Version R7