Sony XCU-CG160C Техническое руководство - Страница 5

Просмотреть онлайн или скачать pdf Техническое руководство для Цифровая камера Sony XCU-CG160C. Sony XCU-CG160C 45 страниц. Digital video camera module

Печатать страницу

Location and Function of Parts and Operation

Front/top/bottom

a Lens mount (C-mount)

Attach any C-mount lens or other optical equipment.

Note

Use a C-mount lens where the protrusion (a) extending

from the lens mount face (b) is 10 mm (13/32 inch) or

less.

When attaching a lens to the camera, note that the

resolution of the image that is output from the camera

may vary depending on the performance of the lens.

The performance of the same lens may also vary

depending on the aperture value.

If the resolution is insufficient, adjust the aperture value.

b Camera mount guide screw holes (top)

c Camera mount guide screw holes/Tripod

attachment screw holes (bottom)

When using a tripod, use these four screw holes to attach

a VCT-333I Tripod Adaptor.

For details, see "Mounting on a tripod" (page 7).

d Camera mount reference screw holes (bottom)

These precision screw holes are for securing the camera

module. Securing the unit with these holes minimizes

any optical axis alignment offset.

For details about the size of and position of guide holes

and reference holes, see "Dimensions" (page 44).

Rear

(DC power input) connector (6-pin)

You can connect a camera cable to input a 12 V DC

power supply. The pin configuration of this connector is

as follows.

(Refer to part e above for the pin assignment of the

connector.)

Pin No.

Signal

DC input

(10.5 V to 15 V)

GPI1 (ISO +)

GPI2/GPO2

f USB connector (Micro B type)

Connect a USB 3.0 cable to control the camera module

from a host device and to send image signals from the

camera module. Power can be supplied from a USB 3.0

interface video input board or from a USB hub over the

USB 3.0 cable.

CAUTION

• For safety, do not connect the connector for peripheral

device wiring that might have excessive voltage to this

port. Follow the instructions for this port.

• Use a Standard USB A to USB Micro B, USB 3.0

cable that is compatible with the USB3 Vision

standard.

• USB 2.0 is not supported.

g Status LED (green)

Displays the unit status.

For details, see "Status LED" (page 30).

Pin No.

Signal

GPO3 (ISO +)

ISO –

GND