Cisco 7513 Series Инструкции по замене Руководство - Страница 16

Просмотреть онлайн или скачать pdf Инструкции по замене Руководство для Сервер Cisco 7513 Series. Cisco 7513 Series 22 страницы. Chassis replacement
Также для Cisco 7513 Series: Краткое руководство по эксплуатации (44 страниц), Инструкции по замене Руководство (26 страниц), Информационный лист (11 страниц), Руководство (30 страниц), Поддержание (20 страниц), Инструкции по замене Руководство (19 страниц)

Replacing the Chassis

Step 9

Step 10

Step 11

Figure 8

Note

This completes the processor module removal and replacement procedure. If you now need to install

the new chassis in an equipment rack, proceed to the section "Installing the New Chassis in the

Rack" on page 10. Otherwise, proceed to the next section to check the installation.

16 Cisco 7513 Chassis Replacement Instructions

Using the thumb and foreﬁnger of each hand to pinch each ejector, simultaneously push

both ejectors inward (toward the carrier handle) until they snap into place and are at a full

90-degree orientation to the faceplate. (See Figure 7c.) The carrier ears (the ends of the

faceplate) should be ﬂush against the chassis.

Use a screwdriver to tighten the two captive screws to prevent the processor module from

becoming partially dislodged from the backplane and to ensure proper EMI shielding.

Repeat Steps 2 through 10 for the remaining interface processors.

Handling a Processor Module

Leave the interface processor ﬁller installed in any unﬁlled interface processor slots.