Cisco 7513 Series Manual de instruções de substituição - Página 16

Procurar online ou descarregar pdf Manual de instruções de substituição para Servidor Cisco 7513 Series. Cisco 7513 Series 22 páginas. Chassis replacement
Também para Cisco 7513 Series: Manual de início rápido (44 páginas), Manual de instruções de substituição (26 páginas), Ficha de dados (11 páginas), Manual (30 páginas), Atualização (20 páginas), Manual de instruções de substituição (19 páginas)

Cisco 7513 Series Manual de instruções de substituição
Replacing the Chassis
Step 9
Step 10
Step 11
Figure 8
Note
This completes the processor module removal and replacement procedure. If you now need to install
the new chassis in an equipment rack, proceed to the section "Installing the New Chassis in the
Rack" on page 10. Otherwise, proceed to the next section to check the installation.
16 Cisco 7513 Chassis Replacement Instructions
Using the thumb and forefinger of each hand to pinch each ejector, simultaneously push
both ejectors inward (toward the carrier handle) until they snap into place and are at a full
90-degree orientation to the faceplate. (See Figure 7c.) The carrier ears (the ends of the
faceplate) should be flush against the chassis.
Use a screwdriver to tighten the two captive screws to prevent the processor module from
becoming partially dislodged from the backplane and to ensure proper EMI shielding.
Repeat Steps 2 through 10 for the remaining interface processors.
Handling a Processor Module
Leave the interface processor filler installed in any unfilled interface processor slots.