Cisco UCS B200 M4 Указания по установке и обслуживанию - Страница 12

Просмотреть онлайн или скачать pdf Указания по установке и обслуживанию для Сервер Cisco UCS B200 M4. Cisco UCS B200 M4 46 страниц. For e5-2600 v4 series cpus
Также для Cisco UCS B200 M4: Указания по установке и обслуживанию (30 страниц), Руководство по обновлению (9 страниц), Руководство по обслуживанию (24 страниц)

Buttons

LED

Health

(Disk Drive)

Buttons

The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper

clip or a similar item. Hold the button down for five seconds, and then release it to restart the server if other

methods of restarting do not work.

The locator function for an individual server may get turned on or off by pressing the locator button/LED.

The power button allows you to manually take a server temporarily out of service but leave it in a state where

it can be restarted quickly. If the desired power state for a service profile associated with a blade server is set

to "off," using the power button or Cisco UCS Manager to reset the server will cause the desired power state

of the server to become out of sync with the actual power state and the server may unexpectedly shut down

at a later time. To safely reboot a server from a power-down state, use the Boot Server action in Cisco UCS

Manager.

The local console connector allows a direct connection to a blade server to allow operating system installation

and other management tasks to be done directly rather than remotely. The port uses the KVM dongle cable

that provides a connection into a Cisco UCS blade server; it has a DB9 serial connector, a VGA connector

for a monitor, and dual USB ports for a keyboard and mouse. With this cable, you can create a direct connection

to the operating system and the BIOS running on a blade server. A KVM cable ships standard with each blade

chassis accessory kit.

Figure 2: KVM Cable for Blade Servers

Cisco UCS B200 M4 Blade Server Installation and Service Note

Color

Description

Off

Can mean either no fault detected or the drive is not

installed.

Flashing Amber

Rebuild drive active. If the Activity LED is also flashing

4 hz

green, a drive rebuild is in progress.

Amber

Fault detected.

Overview