Cisco UCS B200 M4 Указания по установке и обслуживанию - Страница 30

Просмотреть онлайн или скачать pdf Указания по установке и обслуживанию для Сервер Cisco UCS B200 M4. Cisco UCS B200 M4 46 страниц. For e5-2600 v4 series cpus
Также для Cisco UCS B200 M4: Указания по установке и обслуживанию (30 страниц), Руководство по обновлению (9 страниц), Руководство по обслуживанию (24 страниц)

Installing Memory

Step 2

Press gently on the top of the CPU carrier from the exterior side until it snaps into place.

Step 3

Close the socket latch.

Step 4

Hook the self-loading socket (SLS) lever .

Step 5

Hook the SLS lever

Step 6

Thermally bond the CPU and heat sink using the thermal grease provided.

Step 7

Replace the heat sink. The yellow CPU heat sink install guide pins that are attached to the motherboard must

align with the cutout on the heat sink to ensure proper installation of the heat sink.

Figure 14: Replacing the Heat Sink

Step 8

Tighten the four captive screws in the order shown.

To install a DIMM into the blade server, follow these steps:

Procedure

Step 1

Open both DIMM connector latches.

Step 2

Press the DIMM into its slot evenly on both ends until it clicks into place.

DIMMs are keyed. If a gentle force is not sufficient, make sure the notch on the DIMM is correctly aligned.

Cisco UCS B200 M4 Blade Server Installation and Service Note

Servicing a Blade Server