Cisco ASR 5000 Руководство по установке - Страница 14

Просмотреть онлайн или скачать pdf Руководство по установке для Шлюз Cisco ASR 5000. Cisco ASR 5000 33 страницы. Applying power and verifying the installation
Также для Cisco ASR 5000: Руководство по установке (18 страниц), Процедура установки (8 страниц), Руководство по установке (37 страниц)

Checking the LEDs on the SPIO

SPIO Standby LED States

The Standby LED on the SPIO indicates that software is loaded on the card, but it is serving as a redundant

component. For the SPIO installed in slot 25, this LED should be green for normal operation. For the SPIO

installed in slot 24, this LED should be off for normal operation.

The possible states for this LED are described in the following table. If the LED is not green, use the

troubleshooting information in the table to diagnose the problem.

Table 13: SPIO Standby LED States

Color

Description

Green

Card is in redundant mode.

None

Card is not receiving power.

Card is in Active Mode.

The Link LED, associated with a particular SPIO interface indicates the status of the network link. This LED

should be green for normal operation.

The possible states for this LED are described in the following table. If the LED is not green, use the

troubleshooting information in the table to diagnose the problem.

Table 14: SPIO Interface – Link LED States

Color

Description

Green

Link is up.

ASR 5000 System Administration Guide, StarOS Release 21.2

Troubleshooting

None needed for SPIO in slot 25. If green for SPIO in slot 24, check the status

of the SMC installed in slot 8.

If the SMC in slot 8 is in standby mode, it is possible that there is a problem.

Monitoring the System for show commands, the outputs of which will assist in

further determining the problem.

System Logs or information on how to view logs.

The SNMP MIB Reference for information on associated status and alarm

conditions.

Verify that the Run/Fail LED is green. If so, the card is receiving power and

POST test results are positive. If it is off, the card is not receiving power.

Check the state of the Active LED. If it is green, the card is in active mode. This

is normal for the SPIO in slot 24 since the chassis automatically makes the card

active at boot up.

Troubleshooting

None needed.

NOTE: This LED will not indicate the presence of a network link until the

interface parameters are set during the software configuration process.

Troubleshooting