Cisco ASR 5000 Руководство по установке - Страница 29

Просмотреть онлайн или скачать pdf Руководство по установке для Шлюз Cisco ASR 5000. Cisco ASR 5000 37 страниц. Applying power and verifying the installation
Также для Cisco ASR 5000: Руководство по установке (18 страниц), Руководство по установке (33 страниц), Процедура установки (8 страниц)

Applying Power and Verifying the Installation

Channelized Line Card Run/Fail LED States

The Run/Fail LED on the Channelized line card indicates the overall status of the card. These LEDs are

illuminated steady green during normal operation.

If the LED is not green, use the troubleshooting information in the table to diagnose the problem.

Table 25: Channelized Line Card Run/Fail LED States

Color

Green

Red

None

The Active LED on the channelized line card indicates that the operating software is loaded on the card and

that the card is ready for operation.

Installed line cards remain in ready mode until their corresponding packet processing card is activated during

configuration. While in ready mode the Active LED is off. After the packet processing card is activated, the

line card installed in the upper-rear chassis slot behind the packet processing card is also activated. The line

card installed in the lower-rear chassis slot behind the packet processing card enters standby mode.

If the LED is not green, use the troubleshooting information in the table to diagnose the problem.

Description

Troubleshooting

Card powered with no

None needed.

errors detected

Card powered with

Errors were detected during the POSTs. It is likely that the errors

error(s) detected

were logged to the system's command line interface during the

boot process.

Card is not receiving

Verify that the POWER LEDs on the PFUs are green. If they are

power

not, refer to

troubleshooting information.

Verify that the power source is supplying ample voltage and

current to the chassis.

Verify that the card is properly installed per the instructions in

this document.

If all of the above suggestions have been verified, it is possible

that the line card is not functional. Please contact your service

representative.

Card-Level LEDs on the Channelized (STM-1/OC-3) Line Card

Checking the LED on the PFU, on page 5

ASR 5000 Installation Guide

for