Cisco ASR 5000 Руководство по установке - Страница 9
Просмотреть онлайн или скачать pdf Руководство по установке для Шлюз Cisco ASR 5000. Cisco ASR 5000 37 страниц. Applying power and verifying the installation
Также для Cisco ASR 5000: Руководство по установке (18 страниц), Руководство по установке (33 страниц), Процедура установки (8 страниц)
Печатать страницу
Applying Power and Verifying the Installation
Table 2: SMC Run/Fail LED States
Color
Green
Blinking
Green
Red
None
SMC Active LED States
The Active LED on the SMC indicates that the software is loaded on the card and it is ready for operation.
For the SMC installed in slot 8, this LED is illuminated green during normal operation. For the SMC installed
in slot 9, this LED is off during normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 3: SMC Active LED States
Color
Green
Description
Troubleshooting
Card powered with no
None needed.
errors detected
Card is initializing and/or
This is normal operation during boot-up.
loading software
Card powered with
Errors were detected during the POSTs. It is likely that the errors
error(s) detected
were logged to the system's command line interface during boot.
Refer to the System Administration Guide for troubleshooting
information.
Card is not receiving
Verify that the POWER LEDs on the PFUs are green. If they are
power
not, refer to
troubleshooting information.
Verify that the power source is supplying ample voltage and
current to the chassis.
Verify that the card is properly installed per the instructions in
this document.
If all of the above suggestions have been verified, it is possible
that the SMC is not functional. Please contact your service
representative.
Description
Troubleshooting
Card is active
None needed for the SMC in slot 8. If green for the SMC in slot
9, verify that the SMC in slot 8 is installed properly according to
the instructions in this document.
Checking the LEDs on the SMC(s)
Checking the LED on the PFU, on page 5
ASR 5000 Installation Guide
for
9