DIGIWAY PTY P550 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Открыватель двери гаража DIGIWAY PTY P550. DIGIWAY PTY P550 13 страниц. Sliding gate motor
Также для DIGIWAY PTY P550: Руководство по эксплуатации (12 страниц)
Печатать страницуPE trig close (DIP5)
DIP5 ON selects PE beam trig auto close mode. In this mode, if P.E beams trigged and clear the gate
will auto close after gate opened.
Auto CLS (DIP6)
DIP6 ON selects Auto close mode. I this mode, the gate will auto close after standard auto closed time.
If DIP6 OFF, no this function.
5. Control Board Set up
Push Buttons functions
Button
Dip1 on---STD Setting
OPN
Open Length Set
PED
Auto close time set
CLS
Manual close gate
OSC
Lock pulse time set
5.1 STD(standard) time setting mode
To get into standard setting mode, just set DIP1 to on. Following settings can be set in standard setting
model
Gate length set up – (Gate travel distance setup)
a) Connect 240V AC (if not done) and make sure power is off.
b) Releases clutch and push gate to middle position, and then engage the clutch.
c) Make sure no signals connect to OPN, PED, OSC and PEB (use Bypass jumper) terminals. Set
DIP6 on.
d) Turn power on, gate should start close at low speed. If gate opens, turn power off, change motor
direction by swapping any two of three phases output of inverter .
e) Power on again. Gate should start to close. If gate only runs short displace (about 2 seconds time)
then turn power off, change encode plug to other connector.
f) Power on again, gate start close, RED LED is flash and GREEN LED is off. When gate hit the
closed stopper, gate will stop.
g) Set DIP1 on. Push and hold OPN button, gate will start open at low speed. When gate reach
opened position. Just simply release the OPN button. Controller will save the current position as
fully opened position. While hold OPN button, push and release PED button will save current
gate position as PED opened position.
h) Set DIP1 off and push CLS button, gate will start to close. When gate fully closed, gate will be
ready to operate. Then try to open and close. If not satisfied with the position, just repeat step (g)
to (h).
Gate length set up -- Limit switch set up---Automatic Learning ( Heavy dusty mechanical gate
stopper must be installed in opened and closed position)
Do the same things a),b),c),d),e),f) as above
g) Set DIP1 on. Push and hold OSC button, Power up, while hold OSC button, turn DIP1 off, then
release OSC button. Gate will start close at low speed, after hit receiving post, short delay, and then
open at low speed. Gate hit opened stopper, motor automatic stops. Learning is finished.
(When gate is opening, just push and release PED button, controller will save current gate position
as PED opened position)
Auto close time set
Set DISP1 On, push and hold on PED for the auto close time setting. Now the red and green LED
flash fast alternatively, When reached the required time simply release PED button. Set DIP1 OFF.
The gate controller will back to working mode.
DIGIWAY PTY LTD
CONTROL BOARD SETTING
ON=PE CLS
ON=AUTO CLS
SPE Setting
Sync delay time
Motor stop time set
PE close time set
Reserved
6
OFF=NO PE CLS
OFF=NO AUTO CLS
Dip1 off---Running
Full open
Pedestrian open
Close
OSC