DIGIWAY PTY P550 Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Открыватель двери гаража DIGIWAY PTY P550. DIGIWAY PTY P550 13 страниц. Sliding gate motor
Также для DIGIWAY PTY P550: Руководство по эксплуатации (12 страниц)

Печатать страницу

6. Inverter settings

When the gate stops, the inverter's display is opening high-speed frequency and flash. This frequency

can be changed by up and down arrows on the inverter. The following form is the inverter's standard

setting for the automatic gate application. Not mentioned function keep as factory setting.

Function

Acceleration time

Deceleration time

Freq. Upper limit

Freq. Lower limit

SP1 Frequency

Start/Stop/Control

Multifunction Input

Multifunction output

SP2 Frequency

SP3 Frequency

7. Limit switch option

From Software version 4.3 add on limit switch input option. If no limit switch connected, the controller

previous version

works as

or reached pre-set gate length, whichever happen first. It can use one limit switch, either open or close,

or two limit switch, both open and close.

With limit switch, the controllers will automatically CLRER the encoder counting errors when every

time hit limit switch, while without limit switch (previous version) and the controller ONLY clear the

encoder counting error when recycle power.

Here is the limit connection diagram.

Limit switch can be N/O, it can be magnetic, mechanical switch or proxy (PNP, 3 or 5 wires)

When turn DIP2 ON, Open Limit input OLM as open PEB input N/C. When gate in opening cycle if

open PEB is block, gate will stop pen until PEB is clear. Close Limit input CLM as safety switch input

N/C. When safety switch is active, gate will not run.

DIGIWAY PTY LTD

INVERTER SETTING

Function Description

Acceleration time

Deceleration time

Max. Frequency

Min. Frequency

Gate Close High Speed

Terminals

Reset Terminal Function

When inverter runs, relay on

Gate Open Low Speed

Gate Close Low Speed

. If add limit switch, the controller will stop gate either hit limit switch

Setting Unit Note

2.0-2.5

Sec.

2.0

Sec.