DIGIWAY PTY SL2000 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Открыватель двери гаража DIGIWAY PTY SL2000. DIGIWAY PTY SL2000 11 страниц. Sliding gate motor
Печатать страницу
1) Open button
3) Ped button
5) OSC button
7) Display LEDs
9) Motor and transformer fuse
11) Motor supply
13) Motor-1 output
15) Motor-2 limit switch
17) AUX 12V supply@300mA
19) Set DIP switch
4.1 Control inputs
4.1.1 Open (OPN) input & OPN push button
The OPN inputs are Push Button OPN and Terminal OPN input. Push OPN button and activating
(connect OPN terminal to the +12V) the OPN input will start to open the gate. When gate opened,
if OPN is keep activating, the gate will stay open. This is mostly controlled by access control
system.
4.1.2 Pedestrian Access (PED) input and Pedestrian (PED) push button
The pedestrian input partly opens the gate leaf driven by motor1 in the case of single speed mode,
or partly opens gate in the case of sliding gate mode. How far the gate will open depending on the
Pedestrian Open Time, this can be changed by user. If P.E input is activated during the gate is
closing, the gate will reopen for another Pedestrian Open Time. P.E Close setting and Auto Close
setting will also apply to pedestrian cycle.
4.1.3 Close Terminals input (CLS) and Close (CLS) Push button
The CLS terminals input is used to close the gate. Push button on control board is mainly used to
test when finished the installation. Pushing it will cause gate to close if the gate in the opened
position or in the opening cycle. If gate is in the closed or closing, the gate situation is not change.
4.1.4 STP stops input and stop button
STP input and STP button is used for stop the gate and settings
4.1.5 OSC (open/stop/close) input
OSC input and OSC button is used for manual operation. Push to open the gate, push again stop
gate, another push close the gate.
4.1.6 Photoelectric safety beam (PE) input (N/C type)
If the P.E input is activated while gate is closing, the controller will stop the gate or reopen the
gate depending on the DIP setting. If the gate in the opened position and P.E beam is activated, the
gate will stay in opened.
Digiway Pty Ltd
CONTROL INPUIT AND BUTTON
2) Close button
4) Stop button
6) PE button
8) DIP switch for settings
10) 240V AC supply
12) Motor-2 output
14) Lock output
16) Motor-1 limit switch
18) Control inputs
6