DIGIWAY PTY SL2000 Kullanım Kılavuzu - Sayfa 6

Garaj Kapısı Açıcı DIGIWAY PTY SL2000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DIGIWAY PTY SL2000 11 sayfaları. Sliding gate motor

1) Open button

3) Ped button

5) OSC button

7) Display LEDs

9) Motor and transformer fuse

11) Motor supply

13) Motor-1 output

15) Motor-2 limit switch

17) AUX 12V supply@300mA

19) Set DIP switch

4.1 Control inputs

4.1.1 Open (OPN) input & OPN push button

The OPN inputs are Push Button OPN and Terminal OPN input. Push OPN button and activating

(connect OPN terminal to the +12V) the OPN input will start to open the gate. When gate opened,

if OPN is keep activating, the gate will stay open. This is mostly controlled by access control

system.

4.1.2 Pedestrian Access (PED) input and Pedestrian (PED) push button

The pedestrian input partly opens the gate leaf driven by motor1 in the case of single speed mode,

or partly opens gate in the case of sliding gate mode. How far the gate will open depending on the

Pedestrian Open Time, this can be changed by user. If P.E input is activated during the gate is

closing, the gate will reopen for another Pedestrian Open Time. P.E Close setting and Auto Close

setting will also apply to pedestrian cycle.

4.1.3 Close Terminals input (CLS) and Close (CLS) Push button

The CLS terminals input is used to close the gate. Push button on control board is mainly used to

test when finished the installation. Pushing it will cause gate to close if the gate in the opened

position or in the opening cycle. If gate is in the closed or closing, the gate situation is not change.

4.1.4 STP stops input and stop button

STP input and STP button is used for stop the gate and settings

4.1.5 OSC (open/stop/close) input

OSC input and OSC button is used for manual operation. Push to open the gate, push again stop

gate, another push close the gate.

4.1.6 Photoelectric safety beam (PE) input (N/C type)

If the P.E input is activated while gate is closing, the controller will stop the gate or reopen the

gate depending on the DIP setting. If the gate in the opened position and P.E beam is activated, the

gate will stay in opened.

Digiway Pty Ltd

CONTROL INPUIT AND BUTTON

2) Close button

4) Stop button

6) PE button

8) DIP switch for settings

10) 240V AC supply

12) Motor-2 output

14) Lock output

16) Motor-1 limit switch

18) Control inputs