EPSON Stylus COLOR 400
2. Fan a stack of paper and then even the edges.
3. Load the stack with the printable side up and the short edge
first. (Load pre-printed forms and letterhead top edge first.)
Place the paper's right edge against the right edge guide.
Note:
Don't load paper above the arrow mark inside the left
edge guide.
4. Slide the left edge guide back against the stack of paper.
5. Select the
and other printer driver settings that
Media Type
are appropriate for the media you loaded.
10 - EPSON Stylus COLOR 400
Loading Special Media
When loading special media, use the same steps described in
the previous section, but keep the following guidelines in
mind.
EPSON 360 dpi, High Quality, and Photo
Quality Ink Jet Paper
arrow mark
You can load paper up to the arrow mark on the left edge
guide. If you use legal-size ink jet paper, don't load it more
than half way to the arrow mark.
EPSON Photo Quality Glossy Paper, Glossy
Film, and Transparencies
Before loading transparencies, reposition the paper support as
shown on page 9. For media or transparencies, put a support
sheet (packed with the media) or a plain paper sheet beneath
the stack.
You can load up to 20 sheets of glossy paper or up to 30 sheets
of glossy film or transparencies. If you load multiple sheets of
glossy film, the minimum top margin you can use is 1.2 inches
(30 mm). For best results, or to print with a smaller top
margin, load and print glossy film one sheet at a time.
Remove each sheet from the output tray immediately after it is
printed and make sure each sheet is dry before stacking it.
1/97
hw_pig.fm5 (Left) 1/2/97 10:34am
Note:
Some special media have a cut corner that you need to
position correctly; follow any instructions in the package.
Always handle the sheets by the edges, and don't touch
the printable surface.
Caution:
Don't use the cleaning sheets that may be included
with your special media; they may cause a paper jam.
Note:
Use ink jet papers within one year of purchase. Use
glossy media and transparencies within six months.
Store unused media in its original package and keep it
away from high heat and humidity.
Печатать страницу