Dill Retrofit TPMS Руководство - Страница 5

Просмотреть онлайн или скачать pdf Руководство для Системы управления Dill Retrofit TPMS. Dill Retrofit TPMS 16 страниц.

External Antenna Installation

Remove the original antenna from the back of the display unit and replace it

with the coaxial wire antenna via display connector.

Install the magnet/antenna underneath the rear of the vehicle, which will give

it the nearest proximity to the transmitters. Thus, increasing signal reception

between the display/receiver and transmitters.

Do not install the magnet/antenna directly on the trailer.

It is the installer/end user's discretion how to install the antenna and coaxial

wire from the exterior and interior of the vehicle cabin.

Installing the external antenna involves a small degree of experimentation

for maximum signal reception. Temporarily connect the antenna cable to the

display, passing the cable through the vehicle's door or window. This

temporary connection allows you to test the antenna's location. If the

location you have selected for the antenna has difficulty in picking up signals

from all tire locations, change the antenna's location slightly and continue to

test. When signals from all tire locations report, install the antenna

permanently in the vehicle.

Caution: Stay away from transmission, oil and exhaust lines avoiding the

inherent heat from those locations which can melt the coaxial cable.

If proper reception is not achieved with the external antenna, a signal boost

will be required.

A signal booster (part number = 1905) is an optional part for RV's, fifth

wheels and tow-vehicles and trailers. It enhances the signal from the

transmitters. A signal booster is recommended to effectively receive the

signals from each transmitter, when there may be interference from

electronics, RV construction, length, etc.