AEMC instruments 1246 Краткое руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Регистраторы данных AEMC instruments 1246. AEMC instruments 1246 8 страниц. Thermo-hygrometer data logger
Печатать страницуThank you for purchasing the Thermo-Hygrometer Datalogger Model 1246. For best
results from your instrument:
read these operating instructions carefully
comply with the precautions for use
Information or useful tip.
Battery.
Magnet.
The product has been declared recyclable after analysis of its life cycle
in accordance with the ISO14040 standard.
AEMC has adopted an Eco-Design approach in order to design this
appliance. Analysis of the complete lifecycle has enabled us to control
and optimize the effects of the product on the environment. In particular
this appliance exceeds regulation requirements with respect to
recycling and reuse.
Indicates conformity with European directives and with regulations
covering EMC.
Indicates that, in the European Union, the instrument must undergo
selective disposal in compliance with Directive WEEE 2002/96/EC. This
instrument must not be treated as household waste.
Precautions
This instrument is compliant with safety standard IEC 61010-2-030, for voltages up to 5V
with respect to ground. Failure to observe the following safety instructions may result in
electric shock, fire, explosion, and damage to the instrument and/or the installation in
which it is located.
The operator and/or the responsible authority must carefully read and clearly
understand all precautions to be taken prior to using the instrument. Thorough
knowledge and awareness of electrical hazards are essential when using this
instrument.
Observe the conditions of use, including temperature, relative humidity, altitude,
pollution degree, and location of use.
Do not use the instrument if it appears damaged, incomplete, or improperly
closed.
Before each use, check the condition of the housing and accessories. Any item on
which the insulation is deteriorated (even partially) must be set aside for repair or
disposal.
All troubleshooting and metrological checks must be done by accredited
personnel.
2