3Com 3crwe875075a Руководство по конверсии - Страница 6

Просмотреть онлайн или скачать pdf Руководство по конверсии для Беспроводная точка доступа 3Com 3crwe875075a. 3Com 3crwe875075a 10 страниц. Wds bridging and antenna installation
Также для 3Com 3crwe875075a: Руководство по конфигурации (10 страниц), Краткое руководство по эксплуатации (8 страниц)

Conversion in a Running Network

Before converting an access point in a running network, you must:

Install the Wireless Switch in the network.

Ensure that the DHCP and DNS servers have been configured to support wireless

switching as specified in the Wireless Switch Getting Started Guide. When the

access point has been converted, it searches for the Wireless Switch.

Make a note of the MAC address and device serial number of the device to be

converted. Ignore any digits before the slash (/) in the serial number. For example, for

the serial number 0100/ M8XE4QB123456, make a note of 'M8XE4QB123456'.

Add the MAP to the Wireless Switch, preferably using 3WXM. If the device is being

configured as a Distributed MAP (DAP), the serial number must be specified.

If you know the current IP address of the MAP, you can start up your web browser and

enter the IP address of the access point in the address bar. Otherwise follow steps 4 to 6

to find the device and launch the web management interface.

Launch the 3Com Wireless Infrastructure Device Manager, select the network adapter (if

required) and refresh the display. The PC needs to be connected to the same

subnetwork as the access points to be converted.

Select the device to be converted in the Wireless Network Tree. Click Properties and

check that the MAC address corresponds with that of the device to be converted.

Once the correct device has been selected, click Configure. If a password has been set

on the device, enter it when prompted and click Next. This launches the web

management interface for the device.

Enter the username and password when prompted. If the device has not been used

before, the default username is admin and the password field should be left blank. You

may also need to set the country code before you can access the home page.

Click Advanced Setup, select the Administration page, and then go to the

Firmware Upgrade section.

Since the MAP Conversion Software is already loaded on the PC, it can be uploaded to

the access point using the Local option. Click the Browse button and locate the MAP

Conversion Software file. Click Start Upgrade to start the conversion process. The

upload takes place through the HTTP protocol from the local machine.

When the upload is complete, click Reboot. The web management interface can be

dismissed. The 3Com Wireless Infrastructure Device Manager display should be

refreshed. If the conversion is successful, the access point is no longer be visible in the

displayed Wireless Network Tree. The MAP should now be under the control of the

Wireless Switch.