3Com 3crwe875075a Руководство по конверсии - Страница 7

Просмотреть онлайн или скачать pdf Руководство по конверсии для Беспроводная точка доступа 3Com 3crwe875075a. 3Com 3crwe875075a 10 страниц. Wds bridging and antenna installation
Также для 3Com 3crwe875075a: Руководство по конфигурации (10 страниц), Краткое руководство по эксплуатации (8 страниц)

Viewing LEDs in MAP Operation

The LEDs on an access point in MAP mode operate as follows:

LED

Radio

Power

Ethernet

NOTE: The operation of the radio and power LEDs can be used to determine which mode

has been configured on the access point. For example: If the access point is powered on but

is not connected (directly or through a network) to a 3Com Wireless Switch, the Power LED

will flash yellow when in MAP mode and will be lit green when in autonomous mode.

Using the Reset Button in MAP Operation

The Reset button on an access point in MAP mode has two functions:

Momentarily pressing the button during normal operation causes the access point to reset.

Continually pressing the Reset button while the access point is booting begins the

process that converts the access point back to autonomous operation.

NOTE: The Reset button is located behind a small hole on the rear panel of the AP7250, and

between the Power and Ethernet LEDs on the AP8250 and AP8750.

Description

Unlit:

The radio is not installed.

The radio is disabled.

No clients are associated with the radio and there is no traffic activity.

Lights red: A client is associated with the radio.

Flashes slowly: Traffic is being sent or received.

Flashes red rapidly: The radio is unable to transmit. Use the 3Com

Wireless Switch Manager to locate and rectify the problem.

Flashes yellow: The MAP has not been able to locate a Wireless

Switch.

Flashes green: The MAP has located the Wireless Switch but has not

been configured by the Wireless Switch for operational use.

Flashes green: The MAP is in normal operation.

Flashes yellow: A hardware fault has been detected

The operation of this LED is the same in both MAP and Autonomous

configurations.

Flashes yellow: A 10Mbps link is established.

Lights green: A 100Mbps link is established.

Flashes: Indicates activity on the network.

Flashes rapidly: Indicates more activity on the network.