Aeotec Water Sensor 7 Pro Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Аксессуары Aeotec Water Sensor 7 Pro. Aeotec Water Sensor 7 Pro 9 страниц. Water sensor
Также для Aeotec Water Sensor 7 Pro: Руководство (3 страниц), Краткое руководство по эксплуатации (8 страниц), Руководство пользователя (9 страниц), Руководство пользователя (13 страниц), Руководство пользователя (14 страниц)

Печатать страницу
Aeotec Water Sensor 7 Pro Руководство пользователя
17/06/2021
Note: Water Sensor 7 remains awake until the housing is closed again.
Remove your Water Sensor 7 from Z-Wave network.
Your sensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main
controller/gateway. To do this, please refer to the part of your gateways respective manual that tells you how to remove
devices from your network. 
1. Set your Z-Wave controller into unpair mode.
2. Triple-click the tamper switch on Water Sensor 7 within 1.5 seconds - this will cause the LED to blink five times.
3. After a successful exclusion, it will light up its LED for 2 seconds then deactivate.
Reset your Water Sensor 7.
This device also allows being reset without any involvement of a Z-Wave controller. This procedure should only be used
when the primary controller is inoperable. 
To manually factory reset:
1. Remove the cover of Water Sensor 7
2. Press and hold tamper switch for 5 seconds until the red LED blinks.
3. Release the tamper switch
4. Immediately press and hold the tamper switch for 5 seconds until the red LED blinks.
Association Groups
Group Association allows Water Sensor to directly communicate with other Z-Wave devices directly without the need for
the Z-Wave Controller to act as an in-between controller. This using this function will help with communication efficiency
and limit the amount of time it takes to control a device.
Group
Maximum
Number
Nodes
1
5
2
5
3
5
4
5

Parameter setting.

https://help.aeotec.com/support/solutions/articles/6000235950-water-sensor-7-pro-user-guide-zwa019-zwa044-
Water Sensor 7 Pro user guide (ZWA019/ZWA044) : Aeotec Help Desk
Description
Lifeline
Control devices when water leakage is detected
Sends out alarm message when water leakage is
detected
Sends alarm messages when tamper is tripped
6/9