Whirlpool 1CWTW4740YQ1 Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Стиральная машина Whirlpool 1CWTW4740YQ1. Whirlpool 1CWTW4740YQ1 16 страниц.
Также для Whirlpool 1CWTW4740YQ1: Руководство по эксплуатации и уходу (28 страниц)
Печатать страницу
INSTALLATION
REQU[REMENW$
Tools and Parts
Gather required tools and parts before starting installation.
Tools
needed:
@
Adjustable or open end
wrench 9/16"(14 mm)
Level
4 =.n3in
(102 mm}_
ff
Wood block
Ruler or measuring tape
Alternate
parts:
(Not supplied with washer)
Your installation may require additional parts. To order, please
contact the dealer from whom you purchased your washer or an
authorized service company.
If you have:
Overhead sewer
1" (25 mm) standpipe
You will need:
Standard 20 gal. (76 L) 39" (990 mm)
tall drain tub or utility sink, sump
pump and connectors
(available from
local plumbing suppliers)
2" (51 mm) diameter to 1" (25 mm)
diameter Standpipe Adapter
Part Number 3363920
Connector Kit Part Number 285835
Drain hose too short
Extension Drain Hose Part
Number 285863
Connector Kit Part Number 285835
Lint clogged drain
Drain Protector Part Number 367031
Connector Kit Part Number 285835
LOCATION
REQU[REMENWS
Select proper location for your washer to improve performance
and minimize noise and possible "washer walk". Install your
washer in a basement, laundry room, closet, or recessed area.
Pliers that open to 1%6"
(39.5 mm)
Optional
tools:
]
42"
(1067 mm)
Y
Flashlight
Bucket
Parts supplied:
NOTE: All parts supplied for installation are in
cardboard insert in the top of the washer.
Drain hose with clamp,
U-form, and cable tie
"Y" connector
You will need:
[] A water heater set to 120 ° F (49° C).
[] A grounded electrical outlet located within 4 ft (1.2 m) of
power cord on back of washer.
[] Hot and cold water faucets located within 3 ft (0.9 m) of hot
and cold water fill valves on washer, and water pressure
of 5-116 psi (35-800 kPa).
[] A level floor with maximum slope of 1" (25 mm) under entire
washer. Installing on carpet is not recommended.
[] Floor must support washer's total weight (with water and load)
of 315 Ibs (143 kgs).
IMPORTANT:
Do not install, store, or operate washer where it will
be exposed to weather or in temperatures
below 32 ° F (0° C).
Water remaining in washer after use may cause damage in low
temperatures.
See "Washer Care" in your Use and Care Guide
for winterizing information.
Proper installation is your responsibility.
Net hoses
Rubber washer
2