Whirlpool 1CWTW4740YQ1 Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для Стиральная машина Whirlpool 1CWTW4740YQ1. Whirlpool 1CWTW4740YQ1 16 страниц.
Также для Whirlpool 1CWTW4740YQ1: Руководство по эксплуатации и уходу (28 страниц)
Печатать страницу
Recessed
area or closet
installation
14" max.
i
1356 ram)
....
j_ _
,, I'4
E _ _q
* tq
i,ii
511
i tll
iiii
i
(126 m
, ,,,,
• \t ih
\%q
(25 ram)
f
17"'
(432 ram)
%1"
(25 ram)
3 II
(76 ram)
48 in.2
(310 cm2)
24 in.2
(155cm_1
t/22111
(76 ram)
Dimensions show recommended
spacing allowed, except for
closet door ventilation openings which are minimum required.
This washer has been tested for installation with spacing of 0"
(0 mm) clearance on the sides. Consider allowing more space
for ease of installation and servicing, and spacing for companion
appliances and clearances for walls, doors, and floor moldings.
Add spacing of 1" (25 mm) on all sides of washer to reduce
noise transfer. If a closet door or Iouvered door is installed,
top and bottom air openings in door are required.
D IN
SYSTEM
Drain system can be installed using a floor drain, wall standpipe,
floor standpipe,
or laundry tub. Select method you need.
Floor
standpipe
drain
system
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
carry-away capacity: 17 gal. (64 L) per minute. Top of standpipe
must be at least 39" (990 mm) high. For models with 1C prefix,
install no higher than 96" (2.44 m) from bottom of washer. For
models with 2D prefix, install no higher than 48" (1.22 m). if you
must install higher than the recommended
height for your model,
you will need a sump pump system.
Wall standpipe
drain system
See requirements for floor standpipe drain system.
Floor
drain
system
Floor drain system requires a Siphon Break Kit (Part Number
285834), 2 Connector Kits (Part Number 285835), and an
Extension Drain Hose (Part Number 285863) that may be
purchased separately. To order, please contact the dealer from
whom you purchased your washer or an authorized service
company. Minimum siphon break: 28" (710 mm) from bottom
of washer. (Additional hoses may be needed.)
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at
least 39" (990 mm) above floor. For models with 1C prefix, install
no higher than 96" (2.44 m) from bottom of washer. For models
with 2D prefix, install no higher than 48" (1.22 m).
IMPORTANT: To avoid siphoning,
no more than 4.5" (114 mm)
of drain hose should be inside standpipe or below the top of
wash tub. Secure drain hose with cable tie.