Whirlpool 8212638RP Руководство пользователя Руководство пользователя - Страница 12
Просмотреть онлайн или скачать pdf Руководство пользователя Руководство пользователя для Стиральная машина Whirlpool 8212638RP. Whirlpool 8212638RP 29 страниц.
Печатать страницуIMPORTANT: 4.5" (114 mm) of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay on
bottom of laundry tub. Drain hose form must be used.
Connect Inlet Hose
Insert new flat washers
IMPORTANT: To avoid leaks, check that your water inlet hoses
have flat washers at both ends. Machine must be connected to
water faucets with new inlet hoses with flat washers (not
provided). Do not use old hoses. Do not use hoses without
washers.
Connect inlet hoses to water faucets
IMPORTANT: Do not overtighten or use tape or sealants on valve
when attaching to faucets or machine. Damage can result.
Attach the hose labeled hot to hot water faucet. Screw on coupling
by hand until it is seated on washer. Use adjustable pliers to
tighten couplings an additional two-thirds turn. Repeat this step
with the hose labeled cold for the cold water faucet. Both hoses
must be connected for machine to work properly.
Clear water lines
Run water for a few seconds through hoses into a laundry tub,
drainpipe, or bucket to prevent clogs. Water should run until clear.
12
Connect inlet hoses to Machine
IMPORTANT: To reduce risk of hose failure, replace the hoses
every 5 years. Record hose installation or replacement dates for
future reference.
� Do not overtighten hose or use tape or sealants on the valve.
Damage to the valves can result.
� Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Attach hot water hose to hot water inlet valve. Screw coupling by
hand until it is snug. Use adjustable pliers to tighten couplings an
additional two-thirds turn. Repeat with cold water inlet valve.
Check for leaks
Slowly turn on water faucets to check for leaks. A small amount of
water may enter machine. It will drain later.
Secure drain hose
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie or beaded tie strap.
It is the responsibility of the installer to install and secure the drain
hose in to the provided plumbing/drain in a manner that will avoid
the drain hose coming out of or leaking from the plumbing/drain.