Whirlpool 8212638RP Kullanıcı El Kitabı - Sayfa 12

Yıkayıcı Whirlpool 8212638RP için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Whirlpool 8212638RP 29 sayfaları.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay on

bottom of laundry tub. Drain hose form must be used.

Connect Inlet Hose

Insert new flat washers

IMPORTANT: To avoid leaks, check that your water inlet hoses

have flat washers at both ends. Machine must be connected to

water faucets with new inlet hoses with flat washers (not

provided). Do not use old hoses. Do not use hoses without

washers.

Connect inlet hoses to water faucets

IMPORTANT: Do not overtighten or use tape or sealants on valve

when attaching to faucets or machine. Damage can result.

Attach the hose labeled hot to hot water faucet. Screw on coupling

by hand until it is seated on washer. Use adjustable pliers to

tighten couplings an additional two-thirds turn. Repeat this step

with the hose labeled cold for the cold water faucet. Both hoses

must be connected for machine to work properly.

Clear water lines

Run water for a few seconds through hoses into a laundry tub,

drainpipe, or bucket to prevent clogs. Water should run until clear.

Connect inlet hoses to Machine

IMPORTANT: To reduce risk of hose failure, replace the hoses

every 5 years. Record hose installation or replacement dates for

future reference.

� Do not overtighten hose or use tape or sealants on the valve.

Damage to the valves can result.

� Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

Attach hot water hose to hot water inlet valve. Screw coupling by

hand until it is snug. Use adjustable pliers to tighten couplings an

additional two-thirds turn. Repeat with cold water inlet valve.

Check for leaks

Slowly turn on water faucets to check for leaks. A small amount of

water may enter machine. It will drain later.

Secure drain hose

Secure drain hose to laundry tub leg, drain standpipe, or inlet

hoses for wall standpipe with cable tie or beaded tie strap.

It is the responsibility of the installer to install and secure the drain

hose in to the provided plumbing/drain in a manner that will avoid

the drain hose coming out of or leaking from the plumbing/drain.