Whirlpool 27' Руководство по установке - Страница 14

Просмотреть онлайн или скачать pdf Руководство по установке для Сушилка Whirlpool 27'. Whirlpool 27' 48 страниц. Microwave oven and thermal oven
Также для Whirlpool 27': Помощь в работе (36 страниц), Руководство по установке (11 страниц), Руководство по установке (11 страниц), Руководство по установке (22 страниц), Руководство по установке (27 страниц), Руководство по установке (32 страниц), Руководство по установке (12 страниц), Инструкции по установке (5 страниц)

Печатать страницу

Vent System Chart

(Long Vent Models Only)

Number of

Type

90° turns

of vent

or elbows

Rigid metal

Install Vent System

Install exhaust hood

Install exhaust hood and use caulking compound to seal

exterior wall opening around exhaust hood.

Connect vent to exhaust hood

Vent must fit over the exhaust hood. Secure vent to exhaust

hood with 4" (102 mm) clamp. Run vent to dryer location

using straightest path possible. Avoid 90° turns. Use clamps

to seal all joints. Do not use duct tape, screws, or other

fastening devices that extend into interior of vent to secure

vent, because they can catch lint.

Box/louvered, or

Angled hoods

120 ft. (36.6 m)

110 ft. (33.5 m)

100 ft. (30.5 m)

90 ft. (27.4 m)

80 ft. (24.4 m)

70 ft. (21.3 m)

12" min.

(305 mm)

12" min.

(305 mm)

Connect Inlet Hoses

(Steam Models Only)

For non-steam models, skip to "Connect Vent."

The dryer must be connected to the cold water faucet using

the new inlet hoses. Do not use old hoses.

Turn cold water off, remove and

replace rubber washer

Turn cold water faucet off and remove washer inlet hose.

Remove old rubber washer from inlet hose and replace

with new rubber washer.

Attach short hose and

"Y" connector

Attach 2 ft (0.6 m) inlet hose to cold water faucet. Screw on

coupling by hand until it is seated on faucet. Then attach

"Y" connector to end of the 2 ft (0.6 m) inlet hose. Screw on

coupling by hand until it is seated on "Y" connector.

Tighten couplings

Using pliers, tighten the couplings with additional two-thirds

turn.

NOTE: Do not overtighten. Damage to the coupling can result.