Level Dryer
1.
Level dryer
Check levelness of dryer from side to side. Repeat from
front to back.
NOTE: The dryer must be level for the moisture sensing system
to operate correctly.
Not Level
2.
Tighten and adjust leveling legs
If dryer is not level or the same height as the washer, prop up
using a wood block. Use wrench to adjust legs up or down,
and check again for levelness. Once legs are level, make sure
all four legs are snug against the floor before tightening them.
16
LEVEL
Not Level
Complete Installation Checklist
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Check dryer's final location. Be sure vent is not crushed
or kinked.
q
Check that dryer is level. See "Level Dryer."
q
Remove film on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q
Read "Dryer Use" in your "Use and Care Guide."
q
Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
q
Be sure the water faucets are on.
q
Check for leaks around "Y" connector, faucet, and hoses.
q
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which will
reduce product performance. Excessive scale buildup may
lead to the need for certain part replacement or repair.
If the dryer will not start, check the following:
Dryer is plugged into a grounded 3-prong outlet.
■
Electrical supply is connected.
■
Household fuse is intact and tight, or circuit breaker has
■
not tripped.
Dryer door is closed.
■
q
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.
If you do not feel heat, turn the dryer off and check to see
whether gas supply line shut-off valve is open.
If the gas supply line shut-off valve is closed, open it,
■
then repeat the 5-minute test as outlined above.
If the gas supply line shut-off valve is open, contact a
■
qualified technician.
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.
Печатать страницу