Xerox DocuPrint C3055 DX Руководство по настройке - Страница 19

Просмотреть онлайн или скачать pdf Руководство по настройке для Аксессуары для принтеров Xerox DocuPrint C3055 DX. Xerox DocuPrint C3055 DX 33 страницы. Internal hard disk
Также для Xerox DocuPrint C3055 DX: Руководство по установке (8 страниц), Руководство по установке (16 страниц), Руководство по настройке (20 страниц), Руководство по установке (16 страниц)

[Off] (default)

Prints single-byte characters without reducing their sizes.

[On]

Prints single-byte characters in reduced sizes.

Char. Code Table

If the Chinese font kit is installed, select the type of character code table for single-byte

characters. The options are [Graphics] (default) and [Slant].

Page Length

Sets the length of one page (printable area) to [11 Inches] (default) or [12 Inches].

1 inch Skip

Sets whether or not to leave 1-inch space between pages.

The following options are available:

[Off] (default)

Does not leave 1-inch space between pages.

[On]

Leaves 1-inch space between pages. The printer skips a space between cut sheets as it

skips over the perforation on continuous-form paper.

Note

• This feature is available when [Page Position] is set to [CSF Off].

Feed Position

Sets the position where printing starts by the length from the top edge of paper. The options

are [8.5 mm] (default) and [22 mm]. If setting this value in inches, select [0.3"] (default) or

[0.9"].

CR Functions

Sets how to handle CR command.

The following options are available:

[CR] (default)

Performs a carriage return only.

[CR/LF]

Performs a carriage return and then a line-feed.

0 Style

Sets the character style of "0" (zero).

The following options are available:

[Zero] (default)

Uses "0" without a slash (normal style zero).

[Zero (With Slash)]

Uses "0" with a slash through it.

Specify Extension

Sets whether or not to enable the extension specified by selecting [Enable] or [Disable]

(default). When the extension is enabled, printing can be controlled using text codes.

Note

• An extended command is prefixed with an extender followed by command identification data and

parameter data (if necessary). An extension is the first 2 bytes of an extended command (ESC (1BH in

hexadecimal) followed by a ";" (semicolon or 3 BH in hexadecimal)).

2.2 Setting the ESC/P Mode Menu