Xerox DocuPrint C3055 DX Ayarlar Kılavuzu - Sayfa 19
Yazıcı Aksesuarları Xerox DocuPrint C3055 DX için çevrimiçi göz atın veya pdf Ayarlar Kılavuzu indirin. Xerox DocuPrint C3055 DX 33 sayfaları. Internal hard disk
Ayrıca Xerox DocuPrint C3055 DX için: Kurulum Kılavuzu (8 sayfalar), Kurulum Kılavuzu (16 sayfalar), Ayarlar Kılavuzu (20 sayfalar), Kurulum Kılavuzu (16 sayfalar)
Sayfayı Yazdır
[Off] (default)
Prints single-byte characters without reducing their sizes.
[On]
Prints single-byte characters in reduced sizes.
Char. Code Table
If the Chinese font kit is installed, select the type of character code table for single-byte
characters. The options are [Graphics] (default) and [Slant].
Page Length
Sets the length of one page (printable area) to [11 Inches] (default) or [12 Inches].
1 inch Skip
Sets whether or not to leave 1-inch space between pages.
The following options are available:
[Off] (default)
Does not leave 1-inch space between pages.
[On]
Leaves 1-inch space between pages. The printer skips a space between cut sheets as it
skips over the perforation on continuous-form paper.
Note
• This feature is available when [Page Position] is set to [CSF Off].
Feed Position
Sets the position where printing starts by the length from the top edge of paper. The options
are [8.5 mm] (default) and [22 mm]. If setting this value in inches, select [0.3"] (default) or
[0.9"].
CR Functions
Sets how to handle CR command.
The following options are available:
[CR] (default)
Performs a carriage return only.
[CR/LF]
Performs a carriage return and then a line-feed.
0 Style
Sets the character style of "0" (zero).
The following options are available:
[Zero] (default)
Uses "0" without a slash (normal style zero).
[Zero (With Slash)]
Uses "0" with a slash through it.
Specify Extension
Sets whether or not to enable the extension specified by selecting [Enable] or [Disable]
(default). When the extension is enabled, printing can be controlled using text codes.
Note
• An extended command is prefixed with an extender followed by command identification data and
parameter data (if necessary). An extension is the first 2 bytes of an extended command (ESC (1BH in
hexadecimal) followed by a ";" (semicolon or 3 BH in hexadecimal)).
2.2 Setting the ESC/P Mode Menu
19