Yamaha AW2816 Руководство - Страница 30

Просмотреть онлайн или скачать pdf Руководство для Музыкальный инструмент Yamaha AW2816. Yamaha AW2816 32 страницы. Professional audio workstation, recording101
Также для Yamaha AW2816: Руководство по эксплуатации (2 страниц), Руководство по обновлению (2 страниц), Учебное пособие (31 страниц)

Routing an Input Channel via Busses to a Recording Track on an AW2816

One way to route Input Channels to Recording Tracks

is via the eight (8) Busses. The ''Bus-to-Track''

relationships are listed in the following table:

EXAMPLE: If Input Channel 5 is routed to Bus 1 then

the audio from Input Channel 5 can be recorded on

Tracks 1 and 9. However, recording can only occur on

a Track that is actually record enabled or ''armed''.

Starting with Initial Data:

WARNING: All current parameter settings will be lost. If the current settings and data are not expendable,

store the data to an unused Scene before executing the the 'Initial Data' Scene recall.

1) Press the [SCENE] button located above the (DATA/JOG) dial.

2) Press the [F1] button below the screen.

3) Select "00. Initia Data" using the (DATA/JOG) dial.

4) Press the [RECALL] button located above the (DATA/JOG) dial. A confirmation window will

appear, unless 'Recall Confirmation' has been disabled in the 'UTILITIES: Prefer 1. page'.

5) Use the CURSOR' buttons to select 'OK'.

6) Press the [ENTER] button. All existing ''Input-to-Bus'' assignments will be cleared.

Routing an Input to a Bus:

1) Press the [PAN] button to view the main 'PAN/ROUTING' screen.

2) Press the [F1] button to select the 'PAN 1-16' page. On this page, Input Channels 1-16 can be

assigned to the 8 Busses.

NOTE: The numbers '1-16' in this screen represent the 16 Input Channels. Under each Input

Channel, boxes '1-8' represent the 8 busses and the 'ST' box represents the Stereo Bus.

3) Using the 'CURSOR' buttons, highlight the desired Bus under the desired Input Channel.

4) Press the [ENTER] button. The box will be ''filled'' or ''darkened'' when actually selected.

At this point, the selected Input Channel is now assigned to the selected Bus and the audio signal at

the selected Input Channel/Bus can be recorded on the corresponding Recording Track(s). (Refer to

the 'Bus-to-Track Relationships' table above.)

NOTE: The same procedures found in steps 3 and 4 can be used to deselect or unassign an Input

Channel to a Bus. The [ENTER] button will toggle the setting of the selected Bus of the selected Input

Bus-to-Track Relationships

Bus

Recording Tracks

1 and 9

2 and 10

3 and 11

4 and 12

5 and 13

6 and 14

7 and 15

8 and 16