Ecoplus MAG DRIVE UTILITY PUMP 700 GPH Руководство по эксплуатации - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Водяной насос Ecoplus MAG DRIVE UTILITY PUMP 700 GPH. Ecoplus MAG DRIVE UTILITY PUMP 700 GPH 12 страниц.

Печатать страницу

Cleaning and Maintenance

Unit Motor is hermetically sealed with a super quality resin and does not require

any extra care. The only serviceable part is the impeller. The impeller assembly

rest in an easy to open cover that needs to be spot checked for dirt, grime and

mineral build up. Should you discover any worn or damaged areas replace

impeller immediately to restore pump to its full capacity. Pumps ran in salt water

should also be flushed with freshwater after use and before maintenance. It is

recommended that these inspection take place ever 2-3 months depending on

water conditions.

SYMPTOM

The pump doesn't run

The motor repeats on

and off immediately

without pump running.

The motor suddenly

stops and cannot be

started again.

The pump runs normally

at the beginning but the

water flows out slowly

or there is no water.

Replacement Part Information

Replacement parts for your pump are available for purchase online. Please visit

our website at www.ecoplususa.com for more information. The following parts are

available:

Part #

748451

EcoPlus

748456

EcoPlus

748461

EcoPlus

748461

EcoPlus

748471

EcoPlus

Troubleshooting

CAUSE

Power is not turned on

Plugged in insufficiently

Impeller binding

Apply to wrong voltage

The water inflow or outflow

pipe is clogged with foreign

matters

Impeller worn out

Water level does down and

the pump exposed on the

water source

Hose is too long or clogged

with foreign matter

There is air in the impeller

chamber (Only when used

outside water.)

Description

Mag Drive 250PGH Replacement Shaft and Impeller

Mag Drive 350PGH Replacement Shaft and Impeller

Mag Drive 500PGH Replacement Shaft and Impeller

Mag Drive 700PGH Replacement Shaft and Impeller

Mag Drive 900PGH Replacement Shaft and Impeller

RESOLUTION

Turn on power

Plug in sufficiently

Remove foreign matters from impeller

Apply to correct voltage

Remove foreign matters from pipes

Replace it with a new one

Put pump into water

Shorten the hose or clean up inside

In order to get rid of air, put the pump

into the water. Turn the switch to "ON"

then "OFF" intermittently 2 or 3 times.

MSRP

$17.99

$23.99