Clarke 4500633 Инструкции по эксплуатации и техническому обслуживанию - Страница 9
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Электроинструмент Clarke 4500633. Clarke 4500633 17 страниц.
Печатать страницу
Nickel cadmium batteries will slowly lose their power whilst in storage. If they
become fully discharged, do not leave the batteries in this state for any length
of time.
OPERATION
CAUTION: ALWAYS BE SURE THAT THE TOOL IS SWITCHED OFF BEFORE
ATTACHING OR REMOVING A SOCKET. ALWAYS TAKE CARE TO USE THE
CORRECT SIZE SOCKET FOR BOLTS AND NUTS. AN INCORRECT SOCKET
WILL CAUSE DAMAGE TO THE BOLT OR NUT.
1. Align the chosen socket and simply push it onto the anvil. Use only ½"
square drive impact sockets as listed on page 14.
2. Squeeze the trigger to start the machine. Release the trigger to stop.
3. To run the impact wrench in reverse, push
the switch-bar through the drive unit as
shown in Fig 3. The direction of rotation is
shown on the end face of the switch-bar.
• The 3-position switch bar controls forward
or reverse direction of rotation. Select the
appropriate position ONLY when the
machine is STATIONARY. Do not move the
switch-bar when the spindle is moving.
When the switch-bar is in the central
position the trigger is locked.
4. Always check the direction of rotation
before operation.
5. Turn off the machine as soon as the impact
sound is heard.
Note: As the battery becomes discharged, the
power available will drop. Operating the
machine at low speed will cause a reduction in torque.
6. After use, recharge the battery pack as shown on pages 8-9. Avoid leaving
your batteries in a discharged state.
LOOSENING A WHEEL NUT
1. Remove any wheel trim, before selecting the appropriate socket and
placing firmly on the square drive of the wrench.
2. With the FORWARD/NEUTRAL/REVERSE switchbar in the REVERSE running
position, and holding the wrench firmly in BOTH HANDS, pull the trigger. The
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9